-
Your shopping cart is empty!
Glide Marine Bearings are made from Glides' very own GLIDE-100 material, which has virtually no water swell and is one of the most dimensionally stable polymer materials available. Bearings can be machined to the correct clearances without fear of swelling or the clearances disappearing. GLIDE gives you the confidence you need on the water!
For many “synthetic” bearing materials, water swell is a major problem and a major risk for potential shaft seizure. The problem with shaft seizure is that it typically happens over time and most likely comes to a full seizure/lock of shafting at the worst possible time… while out enjoying your boat and potentially leaving you stranded.
Compared to most elastomers, rubbers, nylons, and laminates, GLIDE-100 has low friction. Why is this important? Low friction for a bearing = less heat generated as well as smoother operation and less wear to the whole running assembly. The low static friction of GLIDE-100 is especially beneficial to the low amplitude oscillating movements of rudders. With GLIDE-100, every change of direction occurs smoothly, with a minimal force required and without any jerking or resistance to shaft torque or bearing swell. You will be delighted with the performance improvement compared to conventional materials.
Made in the USA
Made from exclusive GLIDE-100 Material
High performance
Internally lubricated
Polymer bearings
No stress relief when machining
Excellent wear properties
Easily installed (press or freeze fit)
Easily serviced / No electrolytic corrosion
Shaft friendly
Unlimited sizing combinations
No need to grease